|
|
What you need to make 1 necklace:
Strand of 1/8” ribbon about 2” longer than finished desired length
2 crimp tubes
1 closed jump ring
1 clasp
sharp scissors
hammer
2 jewelry bench blocks or other hard surfaces that won’t be damaged if struck by a hammer (Jewelry bench blocks can be found at this link)
|
| |
|
|
|
|
Step 1:
Trim the ends of the ribbon on an angle to make them super pointy. |
| |
|
|
|
|
Step 2:
Feed one end through crimp tube. |
| |
|
|
|
|
Step 3:
Feed the same end through the jump ring and back through the crimp tube. Trim frayed end off if necessary. |
| |
|
|
|
|
Step 4:
Adjust the crimp tube by sliding it up toward the jump ring. It should look like the photo.
|
| |
|
|
|
|
Step 5:
Put on the bench block making sure the jump ring is outside of the bench blocks, but the tube is sandwiched between the blocks. |
| |
|
|
|
|
Step 6:
Hammer firmly once, check to see if the crimp tube is flat and if not, hammer again. |
| |
|
|
|
|
Step 7:
On the other end of the ribbon, trim the end, feed through the tube, then feed through the loop on the clasp, then back through the tube. Measure your ribbon to the final length. Once you have the desired length, slide tube up to, but not touching, the clasp. |
| |
|
|
| |
|
|
|
|
Step 8:
On the other end of the ribbon, trim the end, feed through the tube, then feed through the loop on the clasp, then back through the tube. Measure your ribbon to the final length. Once you have the desired length, slide tube up to, but not touching, the clasp. |
| |
|
|
|
|
CONGRATULATIONS!
You have just created a
beautiful Scrabble Tile
Pendant! String with ribbon
or chain and show all your
friends your beautiful
artwork! |
| |
|
|
| |
|
|
This product and all the
instructions and photographs
contained in this kit are
copyright protected. Any
reproduction or duplication
of the instructions or kit in any
form is in violation of all
copyright laws.
© 2008-2010 Annie Howes |
